DCL’s pneumatic level sensor offers a simplistic
approach to solving the problem of probe selection for the
industries most difficult applications. The sensor will detect the
presence of minus 20 mesh materials whether in a highly fluid state
or at rest. This sensor does not utilize electronics to provide the
actual sensing, therefore it is ideal for high or low temperature
applications.
All pneumatic level sensor adjustments have been set at the factory.
However if the probe does need to be adjusted, there are two
adjustment screws. One located on the pressure switch which adjusts
sensitivity and the other located on the flow meter which adjusts
strength.
The system can be checked for operational function by plugging the
pneumatic level sensor (simulating product presence). This will test
and indicate level full.
