Used in conjunction with aeration conveyor models:
FC6; FC8; FC10; FC12; FC14; FC16; FC18; FC20; FC22; FC24; FC26;
FC28; FC30; FC32; FC34; FC36
Aeration silo penetration adaptors allow material to be withdrawn
from the side of any silo. They can be easily retrofitted in
the field to existing silos when silo bottom discharges are not
possible. The silo penetration adaptor accomplishes this by
passing low pressure air through a porous membrane media and into
the bed of the material being handled. A large variety of
materials can be handled with aeration conveyors regardless of their
abrasive nature or bulk density. The
criteria are particle size, moisture content, and temperature. Generally a
product should have a particle distribution of 100% through a 20
mesh screen. Moisture content should be below 1% and
temperature can not exceed 1200 degrees Fahrenheit
[649° C].
The absence of moving parts and low power requirements make air
gravity conveying the most economical means to convey fine materials
over short or long distances. DCL offers product compatibility
tests in order to determine optimum conveying angles and aeration
volumes. A minimum product amount of 2 cubic feet
[0.07 m³] is required
to conduct a proper test.
DCL offers a large selection of aeration silo penetration adaptors from
6 inches [152 mm] wide up to 36 inches
[914 mm] wide and conveying capacities up to
1000 cubic feet per minute [28.3 m³/min].
Penetration adaptors also are available in a
high top or low top design allowing for maximum flow rate or minimum
head room depending on the application.
A choice of construction materials allow handling of all types of
products; fine, granular, lumpy, abrasive, corrosive, and sanitary
applications.