|
| Flat
Blade Diverter Valve |
Downloads available:
DXF CAD Drawing
Blocks
Application Data Sheet
Equipment Manual
Photo Gallery
Product Literature
Specification Drawings
Models available:
FBOD-6; FBOD-8; FBOD-10; FBOD-12; FBOD-14;
FBOD-16; FBOD-18; FBOD-24; FBOD-30; FBOD-36
FBSD-6; FBSD-8; FBSD-10; FBSD-12; FBSD-14;
FBSD-16; FBSD-18; FBSD-24; FBSD-30; FBSD-36
FBTV-6; FBTV-8; FBTV-10; FBTV-12; FBTV-14; FBTV-16; FBTV-18;
FBTV-24; FBTV-30; FBTV-36
Actuators available:
Pneumatic, electric, hydraulic, and manual hand wheel.
Flat blade diverter valves are designed to direct
product flow from outlets of storage bins, silos, conveyors, gravity
flow chutes and other discharge points handling dry bulk materials.
The FBD housing is constructed of plate steel with cross member
supports on larger sizes. The reinforced blade pivots on two
flanged bearings allowing it to open and close with ease.
Actuation of flat blade diverter valves can be accomplished in many
ways; pneumatically for fast action, hydraulically for power,
electrically for convenience, and manually with a chain wheel or
lever. The seals on the flat blade diverter are designed to
eliminate product leakage when the blade is in the diverted
position. The seals are located at the top, sides, and bottom
of the blade. Blade seals are selected according to the
material being handled and are available to suit any application.
DCL offers a large selection of flat blade diverter valves from
6 inches [152 mm] square up to 36 inches
[914 mm] square. Flat blade
diverter valves are also available in
sizes larger than 36 inches [914 mm] and
in special configurations including hardened liners.
The FBOD flat blade offset diverter valve is configured to direct
the product flow straight through or to one side of the diverter.
Typical product outlets offsets are 30 or 45 degrees off center.
One blade and actuator is used on this diverter valve.
FBSD Flat blade symmetric diverter valves have two product outlets,
each 30 or 45 degrees off center. One blade and actuator is
used on this diverter valve.
The FBTV flat blade triverter valve has one inlet and three outlets.
The two side product are 30 or 45 degrees off the center outlet.
Two blades and actuators are used on this valve.
A choice of construction materials allow handling of all types of
products; fine, granular, lumpy, abrasive, corrosive, and sanitary
applications. A choice of electrical options are also
available allowing for installation in almost any environment; NEMA
4, NEMA 4X, NEMA 7, NEMA 9, 120V/220V control, 460V/415V power, etc. |
|
|
