|
| Tipping
Valve |
Downloads available:
Application Data Sheet
Equipment Manual
Photo Gallery
Product Literature
Specification Drawings
Models available:
TV6; TV8; TV10; TV12; TV14; T16; TV18; DTV6; DTV8; DTV10;
DTV12; DTV14; DTV16; DTV18
Actuators available:
Pneumatic, electric, and gravity.
Tipping valves are designed as a airlock and to
monitor product flow from outlets of dust collectors, filter
modules, and other discharge points handling dry bulk materials.
The tipping valves are very effective inexpensive airlocks.
These valves can be operated individually or two valves can be
mounted together allowing more product flow and offering an even
better airlock. Dual tipping valves have a tandem actuator
configuration which only requires one actuator to actuate each
valve. Actuation of tipping valves can be accomplished in many
ways; pneumatically for fast action, electrically for precise
positioning, and by gravity. The seals are designed to
eliminate product leakage when the blade is in the shut off position
and act as an airlock. Blade seals are selected according to
the material being handled and are available to suit any application
Tipping valves can be suited to handle product at 500 degrees
Fahrenheit
[260° C].
DCL offers a large selection of tipping valves from
6 inches [152 mm] square up to 18 inches
[457 mm] square. Tipping valves are also available in
sizes larger than 18 inches [457 mm]
and in special configurations on a custom build basis.
A choice of construction materials allow handling of all types of
products; fine, granular, lumpy, abrasive, corrosive, and sanitary
applications. A choice of electrical options are also
available allowing for installation in almost any environment; NEMA
4, NEMA 4X, NEMA 7, NEMA 9, 120V/220V control, 460V/415V power, etc. |
 |
|
